Att AUDIX Networking 585-300-903 Manual de usuario Pagina 115

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 268
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 114
DCP Mode 1 Installation and Administration 10-9
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
_ ______________________________________________________________________________________
NOTE
If the faceplate of the MPDM reads ACCUNET, then the D-kit has already been
installed and you should not need to modify the MPDM in any way. In this case, skip
to step 2.
a. Install the 56 Kbps D-181509 kit by following the instructions included with the kit. The D-kit
is used to modify the MPDM so it will work with 56 Kbps facilities.
b. Install the V.35 DTR card in the MPDM. The V.35 card allows a call to be answered without
an attached DTE device.
To see if the V.35 card has already been installed, power up the MTDM without having a DTE
attached. The Terminal Ready LED on the MPDM will be on if the V.35 DTR interface has
previously been installed.
c. Solder two loops or build and connect a male loopback plug to make the connections shown in
Figure 10-5, V.35 Male Connector.
V.35 MALE CONNECTOR
P (Tx1)
R (Rx1)
S (Tx2)
T (Rx2)
Figure 10-5. V.35 Male Connector
2. Install the MPDM/M1* by following the instructions that come with the data module.
3. Set all MPDM option switches to OFF (left) except the following:
Set OFF/56K to 56K
Set ASYNCH/SYNC to SYNC
Set EXT/INT to INT
Set OFF/ANET to ANET
Set OFF/AANS to AANS
Vista de pagina 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 267 268

Comentarios a estos manuales

Sin comentarios