Att AUDIX Networking 585-300-903 Manual de usuario descargar pdf (Pagina 197)

AUDIX Network Testing 14-15

_ ______________________________________________________________________________________

Step 2: Performing Loop-Around Tests

If the appropriate test in Step 1 fails, perform the appropriate loop-around test:

• Near-end connection test

• Local connection test

• Network loop-around 56 Kbps

• Network loop-around 64 Kbps

Step 2A: Testing the Near-End Connection

This tests the loop shown in Figure 14-12, Near End Connection Test (CO DCP Digital Loop-Around), the

loop shown in Figure 14-13, Near End Connection Test (CO DCP Analog Loop-Around), or the loop

shown in Figure 14-14, Near End Connection Test (CO RS-232 Analog Loop-Around).

1. Go to the system : translation : machine : audix/amis/call delivery form

and press ENTER . The local machine proﬁle should be displayed.

2. The network data phone number (or dial string) must be the CO or network access code, a pause, and

the DID number associated with the local network hunt group.

a. Use a plus sign as a pause if testing DCP channels.

b. Use a comma as a pause if testing RS-232 channels. And make sure the dial string starts with

the attention code (ATDT).

3. If a change was required, press CHANGE or RUN , exit the form and go to the maintenance :

audits : fp form. Run a network data audit. This is necessary for R1V3 and R1V4 systems

only; it is not necessary for R1V5 and later systems.

4. Go to the maintenance : network form.

Set select test to 1. Set machine name to the name of the local AUDIX system. Press

CHANGE or RUN . Wait for the result. If the test is not successful, check the system : log

and/or go to Flowcharts For Troubleshooting the Network.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 267 268

Sin comentarios

Att AUDIX Networking 585-300-903 Manual de usuario Pagina 197